How to use your EZ LYNK AUTO AGENT

‍
‍

EZ LYNK AutoAgent 2 AND 3 Installation STEP BY STEP Guide

‍

EZ LYNK’s AutoAgent and AutoAgent 2 & 3 are universal vehicle communication devices that allow you to diagnose, monitor, and program your vehicle. They use cloud based technology to allow you and your mechanic/technician to communicate or transmit data in real-time.

Installation Steps

Living up to the brand name, EZ LYNK has made the installation process simple. We’ve broken down each step and provided some valuable information that will help you understand how your AutoAgent works.
‍

*** NOTICE YOUR EZLYNK TUNER IS PRELOADED WITH YOUR CUSTOM TUNE ALREADY ***

1. Always make sure you have newer batteries.

2. Any aftermarket accessories need to be unplugged or their fuses need pulled.

3. Put a trickle charger on the truck to keep the voltage consistent when flashing the truck Do not use a jump box just a simple car charger.

4. Always tune the truck before removing parts, Do not remove parts until the tuning process has been complete Be very very carefully with all hardware connections be gentle with all cable plugs do not force anything and make sure they are securely fasten before programming your truck and double check everything

Step One: Download & Install the AutoAgent App

The AutoAgent app is available for most smart devices. It requires iOS 8+ or Android 5+ to operate. You can download the IOS app CLICK HERE and the Android app CLICK HERE.

Step Two: Create an Account

From the AutoAgent app, select ‘create an account’. You will need to verify that your email address is valid upon creation. Dealers should always create an account for the end-user or use the account that the end-user has already created.

Step Three: Place Your Key in the ‘Run’ Position

Turn your key all the way over without starting the vehicle. This will boot your vehicle’s engine computer allowing the AutoAgent to communicate with it. If you have a push-to-start vehicle, you should press the Start button twice.

Step Four: Plug the AutoAgent into your OBD-II Port

With the key in the ‘Run’ position, plug your AutoAgent into your vehicle’s On-Board Diagnostics port. You can verify that it has booted correctly when you see that a blue and green light are illuminating from the device.

Step Five: Connect to your AutoAgent from your Smart Device

Navigate to the WiFi settings of your smart device and select the ‘EZ LYNK_####’ network. A check mark will appear next to the network name when you have successfully connected. The AutoAgent 2 also allows you to connect via Bluetooth.

Step Six: Open the AutoAgent App

After you’ve successfully connected, you can navigate back to the AutoAgent app. You should now be able to see your vehicle gauges.

Step Seven: Lynk your Vehicle

When you purchase from Elite Diesels or an authorized Elite Diesels dealer, your vehicle will be AutoLynked DO NOT ENTER A TECH EMAIL IN THERE MANUALLY LET THE TECH EMAIL POP UP THEN SELECT IT. If your smart device has cellular data, you will notice that a message has appeared asking you to lynk the vehicle. Follow these prompts to connect your vehicle with your mechanic/technician. If your smart device does not have cellular data, you will need to connect to an internet available network and re-open the app to complete the EZ Lynk process.

Step Eight: Program Your Vehicle

After completing the Ez Lynk steps you are ready to flash your vehicle.
Navigate to  > Vehicle > ECU Profiles. Here you can view the list of tunes or ECU profiles that are available to you.
Tap the  button to download your desired ECU profile, followed by the ‘Install’ button to flash your vehicle. The app will guide you through the flashing procedure.
(When using a smart devices without cellular data you will need to switch to an internet available network to download the ECU profile, then back to the EZ LYNK network to install the ECU profile.)

IF YOU PURCHASED A LIFETIME SUPPORT PACK AND NEED ADDITIONAL SUPPORT:

Contact us at tech@elitediesels.com

‍